Uses

• Concrete
• Wood
• Foamboard
• Exterior Basement Walls
• Polystyrene/Styrofoam
• Insulation Board
• Concrete Walls (Block or Poured)

Advantages

• Primer for Self-Adhered Foundation Membrane
• Over 300% Elongation – Superior Resiliency & Flexibility
• ECO-Friendly Formulation
• Advanced Water-Based Technology – ZERO VOC
• Bridges Small Cracks

Application

Surface shall be clean, dry and free of any dirt or contaminants. Application temperature must be a minimum of 60 ºF and rising. Do not apply when temperature is expected to drop below 50 ºF within a 24-hour period. Be sure to wear eye protection and gloves when mixing and applying this product. In areas where dew or fog accumulates in the early evening, it is best to coat in the morning. Stop coating by early afternoon (3:00 pm) to prevent wash off, which will occur if dew, fog, or rain arrives before coating dries. Do not apply if rain is imminent or forecast within 24 hours of application. Stir container thoroughly. Apply using either a brush, roller, or airless spray unit (suggested tip size .021 to .025). Apply material at a rate of 150 square feet per 4.75 gallon pail. Allow material to dry and cure for 24 hours prior to application of foam or drainage boards or backfilling. Clean tools with water before material dries.